TROUBLESHOOTING
Burner will not ignite when using the igniter:
Cylinder valve is not on Turn cylinder valve on
Cylinder is empty Replace with a full cylinder
Igniter button is not working Check battery.
Igniter is not sparking Remove plate and visually check ignition box for a spark. Check that
the cable is not broken or disconnected. Also check the alignment of
the sparker. If there is no spark, contact Everdure Service.
Injector is blocked Clean injector with a toothbrush. Do not drill out or use wire. Do not
remove injector. Contact Everdure Service.
Burner flame is erratic:
Burner is blocked Remove burner and check for obstruction
Flame is burning inside
burner (hissing sound)
Turn off burner, allow to cool and re-ignite (page 3)
Regulator is faulty Contact Everdure Service.
Injector is partially blocked Clean injector with a toothbrush. Do not drill out or use wire. Do not
remove injector. Contact Everdure Service.
Gas is leaking from connections:
Connections are loose Tighten loose connections (do not over-tighten) and leak test under
pressure with soapy water solution (page 4)
Hose has deteriorated Replace hose (page 9)
Gas valve is faulty Contact Everdure Service.
Threads are damaged Contact Everdure Service.
MAINTENANCE
It is recommended that, at the commencement of each barbecue season, the following maintenance be
conducted.
BURNER
1. Remove the burner and inspect the port holes, primary air inlet and mixing throat for any signs of
blockage. Clean out with compressed air or a length of wire if necessary.
2. Wire brush the outside of the burner to remove rust and dirt.
3. Replace the burner.
GAS SUPPLY
1. Inspect the gas supply hose for any deterioration and replace it if necessary.
2. Test the gas circuit for leaks and remedy any found.
TROLLEY
1. Check all fasteners for tightness and re tighten where necessary to ensure rigidity of the structure.
2. Wipe over barbecue trolley with a clean cloth.
9
To Next Page
Loading...
