2
TABLE OF CONTENTS
SPECIAL NOTICE AND CALIFORNIA PROPOSITION 65 WARNING 3
CUSTOMER GREETING AND EXPLANATION OF PROCEDURES 4
WARRANTY AND CONTACT INFORMATION 5
SAFETY DISCLAIMER AND HF WARNING 6
SAFETY WARNINGS, DANGERS, CAUTIONS AND INSTRUCTIONS 7
GENERATOR OPERATION INFORMATION 10
REAR OUTLET INFORMATION 10
SPECIFICATIONS 11
DUTY CYCLE INFORMATION 11
BREAKER AND WIRING REQUIREMENT INFORMATION 12
OPERATING AND ELECTRICAL SPECIFICATIONS 13
GETTING STARTED, UNPACKING YOUR UNIT AND INSPECTION 14
CONNECTING YOUR UNIT TO THE POWER SOURCE AND WIRING INFORMATION 15
SHIELDING GAS,REGULATORS, AND TORCH INSTALLATION AND POLARITY INFORMATION 16
INSTALLING MIG WIRE AND DRIVE ROLL SELECTION, MIG GUN DISASSEMBLY AND SETUP 19
FRONT PANEL VIEW AND COMPONENT ID 21
REAR PANEL VIEW AND COMPONENT ID 22
CONTROL PANEL LAYOUT 23
GETTING READY TO WELD/SETTING UP THE UNIT FOR WELDING MANUALLY 26
SETTING UP THE POWERSET MODE 29
EXPLANATION OF MIG FUNCTIONS AND TERMS 31
MIG TORCH COMPONENT BREAKDOWN 35
STICK WELDING INFORMATION 36
COMMON MIG/FLUX CORED ISSUES 38
WARNING SCREENS/ERROR INFORMATION 39
To Next Page
Loading...
