To Next PageTo Next Page
Need help?Do you have a question about the Everlast Storm 215c and is the answer not in the manual?
Warning about chemicals known to cause birth defects and cancer.
Comprehensive warnings covering hazards, PPE, electrical safety, and operational risks.
Guidelines for generator use, EMF, and important operational notices.
Details on warranty claims, contact points, and service procedures.
Steps for unpacking, inspecting, connecting power, gas, and air.
Instructions for setting up MIG, Stick, and Plasma processes, including polarity.
Technical details including duty cycle, breaker, and wiring requirements.
Identification and explanation of front, rear, and control panel components.
Explanation of welding/cutting modes, functions, and techniques for all processes.
List of error codes and their corresponding diagnoses.
Solutions for common problems encountered during MIG/Flux Core welding.
Solutions for common problems encountered during plasma cutting.
General| Input Phase | 1-phase |
|---|---|
| Input Frequency | 50/60 Hz |
| TIG Start | Lift Start |
| Thermal Protection | Yes |
| Overload Protection | Yes |
| Welding Processes | Stick (SMAW), TIG (GTAW) |
| Input Voltage | 120/240V |
| Stick Electrode Size | Up to 1/8" |
| TIG Electrode Size | Up to 3/32" |
