Everlasting BAKING CAB FL 70 - CHAPTER 13 TRANSPORT AND HANDLING; 13.1 Positioning operations

38
ENGLISH
CHAPTER 13 TRANSPORT AND HANDLING
The transport and handling of the retarder-proofer/dough retarder refrigerated cabinet and
refrigerated table must only be done while maintaining the vertical position, observing the markings
on the packaging.
The manufacturer disclaims any liability for problems resulting from transport performed
under conditions other than those specified above.
The accessories of the retarder-proofer/dough retarder refrigerated cabinet and refrigerated table
(guides, grilles, trays, remote condensing unit with pipes) are packaged separately and placed inside
the unit.
The retarder-proofer/dough retarder refrigerated cabinet and refrigerated table are mounted on a
wooden base with screws and packaged with polyethylene, carton, crate or boxes.
Regarding the disposal of the packaging it is necessary to refer to current regulations in your country.
The movement of the retarder-proofer/dough retarder refrigerated cabinet and refrigerated
table shall be performed using a fork lift or pallet trucks equipped with suitable forks (length of at
least 2/3 of the unit).
The dimensions and masses of the retarder-proofer/dough retarder refrigerated cabinet and refrigerated
table packed are shown in Table 1.
The limits of stackability and the centre of gravity are indicated on the label of the package.
13.1 Positioning operations
Since the incorrect positioning of the retarder-proofer/dough retarder refrigerated cabinet and
refrigerated table can cause damage to the same, jeopardizing its proper functioning and cause risks
to the personnel, the installer must comply with the following general rules:
- position the retarder-proofer/dough retarder refrigerated cabinet and refrigerated table keeping a
minimum distance of 3 cm from any wall
- the environment must be sufciently ventilated
- position the retarder-proofer/dough retarder refrigerated cabinet and refrigerated table away from
heat sources
- avoid exposure to direct sunlight
- remove the polyethylene, cardboard or wood packaging