8 Troubleshooting
74/ 106 e’line User Manual | © Eversys AG
S-105 Rinse necessary.
The steam boiler isn't allowed
to heat before the machine is
rinsed.
After switching on the coffee machine, the
steam boiler has to wait until the rinse button is
pressed before it is allowed to heat.
Press the rinse button.
“5.3” on page 39
S-106 Initialize, please wait... Just wait until the coffee machine is initialized. -
S-107 Steam boiler security probe
problem.
Contact service organization. -
S-108 Interface not detected. All
steam and hot water pro-
ducts are locked.
Please check the interface
connection and setting.
This message only occurs if you use an external
interface (CSI or CCI).
“9” on page 79
S-109 Touch Screen open.
Please close the display pro-
perly.
Contact service organization. -
W-002
Coffee boiler is heating...
If this message remains, call your service organi-
zation.
-
W-004 Water flow too low Contact service organization. -
W-006 Check cleaning ball dispenser.
Blocked or broken cleaning
balls. Light barrier dirty?
Contact service organization. -
W-007 The coffee machine has been
cleaned without cleaning
balls.
Cleaning ball dispenser
empty?
Blocked or broken cleaning
balls?
This warning is set if no cleaning ball has been
detected.
Check if the cleaning ball dispenser is empty.
If yes -> Refill it.
Check if a cleaning ball is blocking the dispenser.
If this message remains, call your service organi-
zation.
“7.3.6” on page 68
W-008 Press "Continue" to start clea-
ning now. If you want to start
cleaning later, press the stop
button.
To start cleaning latter, press and hold the rinse
key for three seconds to start cleaning.
“7.3.1” on page 64
W-009 Cleaning ball dispenser mis-
sing.
Contact service organization. -
W-010
Invalid coffee recipe
No action necessary.
This message disappears with the next successful
coffee product.
Normally this message should never appear.
-
W-011 Brewing unit initialization
failed.
The brewing unit is blocked.
=> Please check the brewing
unit.
Contact service organization. -
W-013
Service necessary. Please
contact your service techni-
cian.
The machine has reached the predefined number
of products or the service date interval has
elapsed.
Please call your service technician.
-
# Info message Explanation / Corrective action Refer to
To Next Page
Loading...
