7700 MultiFrame Manual
7700FC VistaLINK® Frame Controller
7700FC-14 Revision 1.4.7
For example:
**** SNMP Setup ****
<1> Read Community String [public]
<2> Read/Write Community String [private]
<3> Trap Setup
<X> Exit
>
6.2.2.2. Trap Setup
“Trap Setup” allows the user to define IP addresses of the trap listeners for when the asynchronous
fault messages are sent. A maximum of five IP addresses can be stored in the Frame Controller. After
selecting “Add…” or “Remove…”, IP address are entered one at a time.
Add Trap
Destinations
Add a SNMP trap server IP address to the TRAP distribution list.
Remove Trap
Destinations
Remove a SNMP trap server IP address from the TRAP distribution list. For
example, selecting this option reveals the list of IP addresses with the prompt to
remove one from the list:
Trap #1: 192.168.1.76
Trap #2: 192.168.8.140
Remove trap # > 2
Show All Trap
Destinations
Displays a list of all entered SNMP trap server IP addresses. For example:
Trap #1: 192.168.1.76
Trap #2: 192.168.8.140
Trap #3: 192.168.8.112
6.2.3. Exiting the Setup Menu
When you are at the main menu, press X to save the configuration to memory. After 30 seconds, A
successful save of the configuration is acknowledged with a commit successful statement, and the user is
returned to the “login” prompt.
For example: (after pressing X<enter>)
**** Main Menu ****
<1> Network Setup
<2> SNMP Setup
<X> Exit
<W> Exit without saving to flash
X
Please wait 30 seconds to save settings to flash…
Commit successful.
NetBSD/evertz <fc-default>
login:
Press W if you made an error during configuration and want to exit the setup menu without saving the new
settings. In either case you will return to the “login:” prompt.
To Next Page
Loading...