14. No motion alarm
Command: V1, xx S/M/H
Note: No spaces in between, S means seconds, M means minutes, H means hours, xx means the time you set and must be two digitals.
Example: V1,05M
If device detect no motion more than 5 minutes and it will send an SMS warning alarm to all registered phone numbers.
To turn off this function, please send V0
15. Turn off 2 LEDs
Command: LED1
The device will reply “LED off” and later LEDs will stop flashing, but the device is actually on.
To turn on LEDs, please send LED0
16. To set number for side button
Command: X1 / X2 / X3 / X4 / X5
Example: X1
Side button can be configured to call which number, if set X1 means it will call number A1. default setting is X2, which means to call number A2.
17. AGPS
Command: AGPS1, latitude, longitude
Example: AGPS1,22.647606,114.022583
Assisted GPS (abbreviated generally as A-GPS and less commonly as aGPS) is a system that is often able to significantly improve the startup performance or ti
me-to-first-fix (TTFF) and improve the GPS location to be more precise, of a GPS satellite-based positioning system.
To Next Page
Loading...