Evinrude e-tec 2005 - Operation; Emergency Stop Switch; Engine Overheating

19
 OPERATION
Tilt UP
Move tilt/run lever to TILT position.
1. TILT position
Grasp tilt grip on engine cover and tilt out-
board to the full tilt position.
1. Tilt grip
Tilt support will automatically engage.
Tilt DOWN
Move tilt/run lever to RUN position.
1. RUN position
Grasp tilt grip on engine cover and raise out-
board slightly.
1. Tilt grip
Tilt support will automatically disengage.
Slowly lower outboard to its normal operating
position.
WARNING
While outboard is tilted, leave tilt lever
in the TILT position. When the tilt/run
lever is in the RUN position, tilt support
can release unexpectedly and allow
outboard to drop, creating a risk of
serious personal injury or loss of con-
trol.
1
1
1
1