Evinrude E-TEC G2 User Manual

31
 Operation
Engine Starting
Turn the key switch fully clockwise to the
START position.
Upon start-up, release the key.
If the engine did not start, release the key mo-
mentarily, then try again.
Each time the key switch is turned from OFF
to ON, the warning system will self-test. Refer
to Engine Monitoring on page 42. If the
warning system fails to self-test during start-
up, see the Service Note on page 64.
If your outboard does not react normally to
this starting procedure or if it fails to start, re-
fer to Troubleshooting on page 63.
After Engine Starts
Check the water pump indicator. A steady
stream of water indicates the water pump is
working. If a steady stream of water from the
water pump indicator is not visible, stop the
engine. Refer to Troubleshooting on page
63.
Engine Stopping
Move control handle to NEUTRAL.
Turn key switch counterclockwise to the OFF
position.
Remove the key when the boat will be unat-
tended.
NOTICE
The starter motor can be damaged if
operated continuously for more than 20
seconds.
007015
1. Water pump indicator
007016
1. Key switch, OFF position
007072
1
1
Key
OFF
ON
START

Evinrude E-TEC G2 Specifications

General

Bore x Stroke	Varies by model
Full Throttle RPM Range	5400-6000 RPM
Alternator Output	133 Amps Total / 50 Net Dedicated
Lubrication	Multi-point targeted oiling
Cylinder Configuration	V6
Gear Ratio	1.85:1
Starting	Electric
Engine Type	2-stroke
Shaft Length	20", 25", 30"
Fuel Induction	Direct Fuel Injection (DFI)
Emissions	EPA 2013
Horsepower Range	150 - 300 HP
Fuel Type	87 Octane
Weight	505 - 635 lbs (varies by model)