EasyManuals Logo

Evinrude E-TEC G2 User Manual

Evinrude E-TEC G2
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
48
Pre-Ride Inspection
WARNING
Always perform a pre-ride inspection before operating the boat. Check the proper
operation of critical controls, safety features and mechanical components. Correct
any problems BEFORE leaving the dock. Make sure all safety equipment required by
local law is onboard.
WARNING
The engine(s) should be OFF and the tether cord must always be removed from the
engine cut-off switch before verifying any of the following. Only start the engine(s)
after all items have been checked and operate properly.
ITEM OPERATION
Hull Inspect.
Propeller
Inspect condition of propeller. Repair or replace
damaged propeller.
Cooling system Inspect water intake screens.
Safety equipment Ensure safety equipment is onboard.
Oil level Check. Refill as needed.
Bilge Drain. Ensure drain plug(s) are securely installed.
Battery
Check battery connections are clean, tight, and
insulated. Ensure battery/battery box are secure.
Fuel level Check. Refill as needed.
Navigation lights Check operation.
Steering system Check operation.
Boat systems (horn, pumps, radio) Check operation.
Engine cut–off tether cord
Inspect condition. Attach tether cord to key switch
(remote control) or engine cut–off switch (tiller
control).
Operator’s Guide
Confirm this Operator’s Guide is onboard and
readily accessible.
Engine Start switch (tiller control) Test operation.
Engine cut–off switch (tiller control) Test operation.
Key switch (remote control) Test operation.
Engine cut–off switch/ tether cord
Test operation. Reattach tether cord to key switch
(remote control) or engine cut–off switch (tiller
control).
Shift and Throttle Check operation.
Cooling system Confirm operation (water pump indicator).

Table of Contents

Other manuals for Evinrude E-TEC G2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Evinrude E-TEC G2 and is the answer not in the manual?

Evinrude E-TEC G2 Specifications

General IconGeneral
Bore x StrokeVaries by model
Full Throttle RPM Range5400-6000 RPM
Alternator Output133 Amps Total / 50 Net Dedicated
LubricationMulti-point targeted oiling
Cylinder ConfigurationV6
Gear Ratio1.85:1
StartingElectric
Engine Type2-stroke
Shaft Length20", 25", 30"
Fuel InductionDirect Fuel Injection (DFI)
EmissionsEPA 2013
Horsepower Range150 - 300 HP
Fuel Type87 Octane
Weight505 - 635 lbs (varies by model)

Related product manuals