Evinrude E-TEC G2 User Manual

83
Readiness Test
The Operator’s Readiness Test....
1. Did you read this Guide from front cover to rear cover?
2. Are you ready to take responsibility for the safe operation of your boat and outboard?
3. Do you understand all the safety precautions and instructions contained in this Guide?
4. Do you understand that this Guide contains essential information to help prevent personal
injury and damage to equipment?
5. Are you ready to follow the recommendations in this Guide and take a boating safety
course before you operate your boat and outboard?
6. Do you know who to ask if you have any questions about your boat and outboard?
7. Do you know your local marine traffic laws?
8. Do you understand that human error can be caused by carelessness, fatigue, overload,
preoccupation, unfamiliarity of operator with the product, drugs and alcohol, just to name
a few?
 WARNING
It is impossible for this Guide to cover every hazardous situation you may encounter;
however, your understanding of and adherence to essential information contained in
this Guide will build good judgment when boating. Always be alert and careful: a
good foundation for safety.

Evinrude E-TEC G2 Specifications

General

Bore x Stroke	Varies by model
Full Throttle RPM Range	5400-6000 RPM
Alternator Output	133 Amps Total / 50 Net Dedicated
Lubrication	Multi-point targeted oiling
Cylinder Configuration	V6
Gear Ratio	1.85:1
Starting	Electric
Engine Type	2-stroke
Shaft Length	20", 25", 30"
Fuel Induction	Direct Fuel Injection (DFI)
Emissions	EPA 2013
Horsepower Range	150 - 300 HP
Fuel Type	87 Octane
Weight	505 - 635 lbs (varies by model)