Evinrude E-TEC G2 User Manual

53
 Engine Emissions Installation Information
EPA Emission Regulations
All new 1999 and more recent Evinrude outboards manufactured by BRP are certified to the
EPA as conforming to the requirements of the regulations for the control of air pollution from
new watercraft marine spark ignition engines. This certification is contingent on certain adjust-
ments being set to factory standards. For this reason, the factory procedure for servicing the
product must be strictly followed and, whenever practicable, returned to the original intent of
the design. The responsibilities listed above are general and in no way a complete listing of
the rules and regulations pertaining to the EPA requirements on exhaust emissions for marine
products. For more detailed information on this subject, you may contact the following loca-
tions:
U. S. Environmental Protection Agency
Office of Transportation and Air Quality
Certification Division
Gasoline Engine Compliance Center
2000 Traverwood Drive
Ann Arbor, MI 48105
EPA Internet Web Site:
www.epa.gov/otaq

Evinrude E-TEC G2 Specifications

General

Bore x Stroke	Varies by model
Full Throttle RPM Range	5400-6000 RPM
Alternator Output	133 Amps Total / 50 Net Dedicated
Lubrication	Multi-point targeted oiling
Cylinder Configuration	V6
Gear Ratio	1.85:1
Starting	Electric
Engine Type	2-stroke
Shaft Length	20", 25", 30"
Fuel Induction	Direct Fuel Injection (DFI)
Emissions	EPA 2013
Horsepower Range	150 - 300 HP
Fuel Type	87 Octane
Weight	505 - 635 lbs (varies by model)