KC PRIME
8
PRINTER OPTIONS
By default, the bezel emits a flashing light
signal when a card is inserted or a card is
issued.
If the card issued is not taken by the end user,
it remains in the bezel.
It is possible to change default setting through
commands.
Anti-insertion optional feature prohibits the
insertion of the card by a user but allows card
issuance.
LED flashing bezel
(rear side)
Encoding stations
Options are described below. They may be already integrated in the printer or provided separately. In this case, their shipped kits contain all
instructions of installation.
Please refer to the driver User Guides (www.evolis.
com>Drivers&Support>printer>Manual and Documents) for all settings linked to
these options.
Duplex activation
To Next Page
Loading...
