Evolution Dog Wash Owners/Operators Manual Page 17
Remove all boxes and wrapping from the unit and set aside. DO NOT use a razor knife when
removing wrappings to prevent possible damage to decaling or stainless-steel surface.
R
emove the Kick Panel by the 4 screws that hold the panel in place. The unit is mounted on a
shipping skid that is held in place with 4 lag screws. Prior to removing this skid, it is
recommended to position the unit in close proximity of its final location. Remove the lag screws
in the shipping skid to remove it from the unit and position the unit into the final location
leaving adequate room to access the unit to connect to water, electricity, and sanitary sewer.
Remove Hold Down Lag Screws (qty 4)
Screws
To Next Page
Loading...