Evolution Dog wash - Water; Electrical

Evolution Dog Wash Owners/Operators Manual Page 22
4.4.2 Water
Water connection should be brought to the unit with external shut off valves to assist in connect
and disconnect functions. Adequate water lines should be used that will support the necessary
water pressure needed.
½
” Female / ¾” Male - pipe threads fittings are provided on the unit for water supply
connections. Connect water supply lines to these fittings.
5
Water (Required)
Cold Water Line 20-60 PSI/2.0 GPM
(Optional) Hot Water Line 20-60 PSI/2.0 GPM
4.4.3 Electrical
A
qualified electrician should only make the electrical connections to
the unit aware, trained, and skilled in the connection of electrical
components. An untrained person performing these functions risks
the chance of serious injury or possibly death. Provide a 120 Volt AC
30 Amp Dedicated circuit to the unit. Observe all local and national
codes when providing power to the unit. This circuit is for the unit
alone, no other appliance should be connected to this circuit.
5
There will not be a hot water plumbing connection if a water heater is provided.
Connect Dedicated 120 VAC / 30
Amp circuit through hole and into
bottom of electrical panel.
Shut off Valves
Water Supply Fittings