EasyManua.ls Logo

Evolution FORESTER Series - SPEEDOMETER; SPEEDOMETER OVERVIEW; SPEEDOMETER OPERATION

Evolution FORESTER Series
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OWNER MANUA L
EVOLUTION
Read carefully all the safety statements before attempting any procedure.
EVOLUTION
PAG E 50
OWNER MANUA L
Read carefully all the safety statements before attempting any procedure.
1
2
VEHICLE MAINTE NANCE VEHICLE MAINTENANCE
PAG E 49
ELECTRIC COMPONENTS MAINTENANCE
DANGER
Check the headlight back rubber caps , the caps
should always be kept on tightly. Otherwise
water or dust may enter into the headlight
chambers. Cause halogen bulbs burn down
easily and vague vision of headlights .
Keep LED rear lights waterproof , keep the cover
lid tight ,keep dust and water out of LED light
assembly.Dense humidity or water may cause
LED diodes burnt down .
DO NOT LOAD LED LIGHTS WITH HIGH
VOLTAGES .
Keep the controller from water , water may cause
circuitry short. If water enter into controller, the
vehicle may not run unintentionally after turn on
the power switch.
Check fluid level before and after charging,
electrolyte should be at least 1/2(13mm)above
the plates and 1/4” tp3/8(6 to 10mm) below
bottom of the vent .
NEVER CHARGE BATTEY WITH LITTLE
ELECTROLYTE , IT MAY CAUSE OVERHEATED
OR EVEN EXPLOSION
CAUTION
WATER
ELECTRIC COMPONENTS MAINTENANCE
CAUTION
WATER
Use a hydrometer to check the specic gravity of
the battery fluid in each cell .Fluid density ranges
from dierent values in dierent period of battery
using.
Maintenance period :One time per 1 months
Use a injection faucet to inject distilled water into
the battery when the battery does not have enough
capacity of battery fluid .
>Always remember to take precautions while conducting any operations on batteries.
>Wear gloves to protect person from acid corrosion. Wear glass to protect person from acid splash.
>Use proper lifting techniques when moving them. Always lift the battery with a commercially
available battery lifting device.
>Wrap wrenches with electric tape to prevent the possibility of a dropped wrench from ‘shorting out
a battery, which could result in an explosion and severe personal injury or death

Table of Contents