OWNER MANUA L
PAG E 13
EVOLUTION
Read carefully all the safety statements before attempting any procedure.
EVOLUTION
PAG E 14
OWNER MANUA L
Read carefully all the safety statements before attempting any procedure.
PRE-OPERATION SAFETY AND PERFORMACE INSPECTION
OPER AT ION AND CONTROLS OPER AT ION AND CONTROLS
Before initiate using vehicle, the batteries
should be fully charged.
Check the accelerator pedal ,when stepped
and released it should returns to its original
position with full flexibility .
Check the brake pedal , when stepped it
should be flexible and feels firm . And it returns
to its original position with flexibility when
released.
Check the tires’ pressure ,it should be inflated
until the internal pressure is around 20PSI
(138kpa)
Check the signal lights , the brake lights and
turning lights should be in proper working
condition .
Check the reverse beeper ,when the direction
selecting switch be set at “REV”, it should beep
soundly
Check the tires’ surface , remove any embedded
objects you can find . Be sure no cracks or other
damages to the tires ,defective tires may cause
accident while driving .
Check the lubricant capacity the rear axle contains,
use a cleaned stick , stick it into the rear axle and
it reach the bottom , pull it out check the depth.The
amount of oil should be around 0.8L.
Pull the steering wheel up and down ,check the
tightness of steering wheel .Rotate the steering
wheel right and left. Be sure no excessive free
play and rattling sound .
Check the tightness of the battery cables , make
sure all the nuts are solidly tight. Loose
nuts on the battery will cause big spark while
operating .
PRE-OPERATION SAFETY AND PERFORMACE INSPECTION
To Next Page
Loading...