◦ As the configuration tool is a web-based interface, you can access it using a web browser.
From any workstation, type the URL of the LSM-VIA workstation in a web browser:
http:\\IPaddress:8080.
◦ From the LSM-VIAViewer window on the LSM-VIA workstation, click the button and
select Settings.
2. Edit the values of the relevant parameters. See sections "System Settings" on page 23 and
"Infrastructure Settings" on page 20.
3. Click Save.
Reset, Cancel, Save
• The Reset, Cancel and Save buttons apply to all the tabs at once.
• After a reset, you must save the changes, but you can also cancel the reset operation.
Parameters with Fixed Value on LSM-VIA
Some parameters, which cannot be edited in the LSM-VIA configuration tool, have a fixed value for the
current version of LSM-VIA. This can therefore not be edited in the current version.
Enable PGM+PRV Mode
The PGM+PRV mode is always set to Active, that means available on the Remote Panel.
Video Effect
The transition between playlist elements is always a Mix.
Should the parameter correspond to a parameter available in the Multicam configuration
module of the controlled EVS server, the Multicam parameter will not be taken into account.
INSTALLATION AND CONFIGURATION MANUAL
LSM-VIA |6. Configuring LSM-VIA| 19
To Next Page
Loading...
Need help?
General