EVS LSM-VIA - Disabling or Enabling Port 80 Forwarding

• The LSM-VIA option must have been selected in the VIAController Settings area during the Multicam
configuration (Channels tab):
• 2 EVS Remote must have been assigned to RS422 ports from the Port settings area during the
Multicam configuration.
Prerequisites on the LSM-VIA Workstation
Some prerequisites are applicable to the LSM-VIA workstation.
• The appropriate configuration for the monitor connectivity has to be defined on the LSM-VIA
workstation.
See section "Setting up the Monitor Connectivity on LSM-VIA Workstation" on page 6.
• To use LSM-VIA with Active Directory, the approprite configuration must be set.
See section "Configuring an Active Directory on an XClient-VIA" on page 6.
2.2.DisablingorEnablingPort80
Forwarding
Context of Use
• To make the device more secure, the port 80 forwarding should be disabled.
◦ With LSM-VIA versions prior to 1.2, the port forwarding was enabled by default during the
installation.
◦ On workstations upgraded with LSM-VIA version 1.2, the installation does not disable the port
forwarding.
◦ On workstations where the first LSM-VIA version installed is the 1.2, the port forwarding is
disabled by default.
If you need to edit the LSM-VIA configuration from another workstation, the port 80 must be
open.
4| January 2022 | Issue 1.4.G