EVS XS - Rs422 Connector; Audio Configurations; Coda for Xs

XS Series DISK RECORDER - Version 10.03 - Hardware
Technical Reference Manual
Issue
10.03.B
EVS Broadcast Equipment SA
–
March 2010
33
2.5 RS422 CONNECTOR
The RS 422 cable must be wired PIN TO PIN following the above diagram. Use
shielded cable to avoid electromagnetic interference on long distances.
Important
If a Reset command can be sent through the Pin n°5 of RS422
connector, this function should be disabled when the controller on
RS422 #1 is not an EVS controller
(refer to the section ‘MTPC Board’ on
page 67 of this manual).
The technical specifications for the RS422 connector are the following:
• 19200 bauds
• No parity
• 8 data bits
• 1 stop bit
2.6 AUDIO CONFIGURATIONS
2.6.1 CODA FOR XS
Internal Audio Module: Embedded + AES/EBU + Analogue Balanced
• Embedded Audio 64 channels (input or output)
• AES/EBU Audio 16 inputs + 16 outputs (110 Ohm balanced on SUB-DB15,
breakout cable with 4 XLR IN/OUT available optionally OR 75 Ohm unbalanced
on BNC)
• Analogue Balanced audio 8 inputs + 8 outputs (110 Ohm balanced on SUB-
DB15, breakout cable with 4 XLR IN/OUT available optionally OR XLR)
• Audio monitoring : 4 analogue balanced mono outputs (XLR)