26
©2018, Industrial Test Systems, Inc. Printed in USA
USING THE EXACT IDIP
®
APP
CONNECT TO PH
+
SELECT
BLUETOOTH
®
TEST
Tap the menu slide out ‘ ’
and select
'Bluetooth Test'
from the choices shown.
CONNECT EXACT
®
PH
+
The eXact iDip
®
app will automatically connect to the
most recently used device. If not, select your eXact
®
pH
+
from the bottom of the screen.
After connecting,
proceed with test procedure for chosen parameter.
Once connected to the pH
+
, you can run tests as usual (see
page 10). Test results will be stored in the Results section of
the app (see page 28 for next steps).
Note: Ensure you always connect your pH
+
photometer via the
Bluetooth
®
connection within the app. To verify connection look for
the Bluetooth icon in the upper right corner of your photometer.
If you experience an issue connecting your device, check to
ensure that your smartphone/tablet’s Bluetooth
®
function is turned
on and your device is compatible.
Refer to the back of your
pH
+
to determine the serial
number for your device. This
will also be the name for the
Bluetooth
®
connection.
TIP
Easily verify your device.
Not Connected
Date/Time Sync Successful
Check LCD display for Bluetooth icon.
To Next Page
Loading...
Need help?
General
