eXact pH+ User Manual

4
©2018, Industrial Test Systems, Inc. Printed in USA
KIT OVERVIEW
GETTING STARTED
If fi rst-time use, or if the meter hasn’t been used for a long time, pour about 5mL of
3M KCL storage solution into the probe cap (about 1/5 of the cap) and soak probe
for a minimum of 15 minutes. Rinse the probe and place into the storage solution.
When not in use, store the pH probe in a pH 4.00 buffer solution. Use enough to
completely immerse the pH glass bulb. If the probe was stored dry, soak in pH
4.00 buffer for at least 4 hours to restore the probe’s sensitivity. Soak the probe for
12 hours to achieve maximum accuracy.
If the unit is stored dry, the probe will not be permanently damaged, but will
temporarily lose its stability. Stability can be restored by soaking the probe in the
supplied 3M KCl storage solution (one 10ml bottle of storage solution comes with
the kit). If this solution becomes cloudy replace it as soon as possible.
* DO NOT use a different brand of storage solution. Using a different chemical
may, potentially, cause the probe to function poorly (also void the warranty).
+
+
-
-
+
+
-
-
INSTALL "AAA" BATTERIES
1. Pull up the battery cover with clip.
2. Slide the battery cap in the direction of arrow.
3. Open the battery cap
4. Insert the batteries (ALL POSITIVE SIDES FACING UP)
5. Close the battery cap
6. Slide and lock the battery cap in the direction of arrow
7. Replace the battery cover with clip. Be sure to push all the way down.
Waterproof design may be compromised if cap is not fi tted correctly.
KIT
CONTAINS
PART NUMBER
eXact
®
pH
Multi Kit
eXact
®
pH
+
meter (with pH probe), four AAA
batteries, lanyard, 3M KCl storage solution,
two pH calibration bottles, two pH calibration
solutions, two conductivity calibration bottles,
two conductivity calibration solutions, pH+
sample collection bottle
486301
eXact
®
ORP
Kit
eXact
®
pH
+
meter (with ORP probe), four AAA
batteries, lanyard, 3M KCl storage solution, pH+
sample collection bottle
486302
eXact
®
Master Kit
with ORP
and pH
eXact
®
pH
+
meter (with pH probe), ORP probe,
four AAA batteries, lanyard, 3M KCl storage
solution, two pH calibration bottles, two pH
calibration solutions, one conductivity calibration
bottle, two conductivity calibration solutions, pH+
sample collection bottle
486303

eXact pH+ Specifications

General

pH Range	0.00 to 14.00 pH
Resolution	0.01 pH
Waterproof Rating	IP67
Temperature Resolution	0.1 °C / 0.1 °F
Temperature Accuracy	±0.5 °C / ±1 °F
Calibration	Automatic, up to 3 points
Power Source	4 x AAA batteries
Temperature Compensation	Automatic