eXact pH+ User Manual

27
exactpH.com
USING THE EXACT IDIP
®
APP
LANGELIER SATURATION INDEX (LSI)
Refer to the instructions and perform the tests for TDS
(page 15) and pH (page 12). Then, obtain results for Total
Alkalinity and Calcium Hardness via alternate means (eXact
iDip
®
photometer - Part No. 486101 or eXact
®
Micro 20
photometer - Part No. 486700). Lastly, tap Results at the
bottom of the page and an LSI value will be calculated and
displayed automatically.
MANUAL ENTRY
This feature allows you to utilize other testing methods and
manually enter your results into the app. Begin by selecting
'Test', 'Manual Entry', select your desired test. Enter the value
obtained. Once fi nished, tap 'SAVE' at the top left. If the test
you need to enter is not available on the list, tap 'Custom*'.
Enter the type of test that was run, the value obtained, and the
unit of measure used. Then, tap 'SAVE' at the top left.
AUTO-CALCULATED METHODS
Visit exactph.com for complete test instructions.

eXact pH+ Specifications

General

pH Range	0.00 to 14.00 pH
Resolution	0.01 pH
Waterproof Rating	IP67
Temperature Resolution	0.1 °C / 0.1 °F
Temperature Accuracy	±0.5 °C / ±1 °F
Calibration	Automatic, up to 3 points
Power Source	4 x AAA batteries
Temperature Compensation	Automatic