Need help?Do you have a question about the Excel AG Series and is the answer not in the manual?
General| Model | AG Series |
|---|---|
| Category | Industrial Equipment |
| Power Source | Pneumatic |
| Type | Air Grinder |
| Air Inlet Size | 1/4" NPT |
Ensure operation uses the specified power source type and consult supplier if unsure.
Avoid overloading outlets and cords to prevent fire or electric shock.
Only use manufacturer-recommended attachments to avoid hazards.
Unplug machine before cleaning and use suitable cleaners for production.
Route power cord to prevent it from being walked on or pinched.
Ensure ventilation slots and openings are not blocked for reliable operation.
Unplug and refer to qualified personnel for damaged cords or abnormal operation.
Do not attempt self-servicing; refer all repairs to qualified service personnel.
Use only manufacturer-specified replacement parts to avoid hazards.
Place on a flat floor with adequate space, considering temperature and humidity.
Verify voltage, use earthed sockets, and disconnect power when not in use.
Use only dry compressed air with a 10mm hose nipple.
Consult manual for doubts; contact supplier for malfunctions. Stop machine and disconnect power if needed.
Machine fills via auger screw rotation; agitator loosens material; cycle adjustable via HMI.
Verify power supply, air pressure, emergency stop, and machine guards are in place.
Familiarize with the touch-screen interface, including clock, firmware, and message displays.
Understand recipe selection, filling targets, pulse settings, and mode selection on the home screen.
Configure target weight, filling pulse, speed, and automatic intervals for recipes.
Adjust agitator speed, stop delay, auger screw model, and acceleration time.
Set re-fill delays, collection funnel open/close delays for specific recipe configurations.
Control agitator, screw conveyor, and collection funnel status; activate cleaning mode.
Regular servicing ensures operation, reliability, and maintains guarantee validity.
Disconnect power before maintenance and avoid wetting electronic parts.
Clean residuals from measuring plates and platforms at the end of each work-shift.
Regularly check for loose screws on all components for reliable operation.
Contact supplier or manufacturer for doubts about maintenance or machine malfunctions.
To Next Page