108
209173 RCD-2
Index A
Operation
- The inverter is fully automatic.
- A remote control is located near the boat's switch panel. To start the converter put the switch on the invertor in the
"REMOTE" position then put the switch located on the remote control in the "ON" position.
- If the switch on the inverter is in the "OFF" position, you cannot use the remote control to start it.
- The DC/AC converter operates by default when shore power is not supplied. It is controlled by a relay connected to the
shore power supply. This converter powers the indoor sockets and some onboard appliances.
- When shore power is not connected, the relay automatically connects the inverter to a part of the onboard AC circuit.
- When the shore power socket is plugged in and powered, the relay automatically disconnects the inverter.
Maintenance
- Check at least once a year that the inverter cables and connections are securely tightened.
- Clean the inverter by removing any accumulated dust to ensure good ventilation.
Control located on the equipment
Remote control
Location: Chart table
- Refer to the manufacturer's instructions for
use and maintenance.
- NEVER:
- connect the inverter AC lead to an AC
terminal or to the onboard generator.
- disconnect the wiring from the inverter
when in use.
- open the inverter.
Electrical system
To Next Page
Loading...