21
TREADMILL FUNCTIONS
SAFETY LOCK FUNCTION:
Removing the Safety Tether Key from the computer console while the treadmill is in motion will
cause the walking belt to stop immediately. The window display of the computer will show “- - -” and
the console will beep 3 times. To start the treadmill again, insert the magnet end of the Safety
Tether Key onto the computer console and press the START button.
POWER SAVE FUNCTION:
After 10 minutes of inactivity the treadmill will enter Power Saving Mode. While the treadmill is in
this mode, the console display will be turned off. Press any button to turn the display back on.
POWER ON:
This icon on the power switch means the power switch is set to the ON position.
POWER OFF:
This icon on the power switch means the power switch is set to the OFF position.
SAFETY NOTE:
1. Maintain a slow speed at the beginning of each session and hold onto the handrails until you
have become familiar with the treadmill.
2. Place the magnet end of the Safety Tether Key on to the console panel and clip the opposite end
to your clothing before starting your workout. To end your workout, press the STOP button or
remove the Safety Tether Key to bring the treadmill to a stop.
To Next Page
Loading...
