Exmark LAZER Z X Series User Manual (English)

Other manuals for Exmark LAZER Z X Series

Questions and Answers:

N
nhillSep 9, 2025
What to do if the clutch will not engage on my Exmark LAZER Z X Lawn Mower?
- V
  vmitchellSep 9, 2025
  If the clutch on your Exmark Lawn Mower won't engage, begin by checking for a blown fuse and replace it. Inspect the coil resistance, battery charge, charging system, and wiring connections, replacing them if necessary. Low voltage supply at the clutch can cause this issue, so check the same components. If the coil is damaged, the clutch will need to be replaced. Inadequate current supply can also be a factor; repair or replace the clutch lead wire or electrical system, and clean the connector contacts. Lastly, if the rotor/armature airgap is too large, remove a shim or replace the clutch.
B
Brent BrownSep 12, 2025
Why does my Exmark Lawn Mower pull left or right?
- S
  sarah35Sep 12, 2025
  If your Exmark Lawn Mower pulls to the left or right even when the levers are fully forward, the tire pressure in the drive tires may not be correct. Adjust the tire pressure in the drive tires to resolve this issue.
D
Dylan HatfieldSep 12, 2025
What does it mean if the oil temperature light is on and engine RPM is low on my Exmark LAZER Z X?
- V
  Valerie SpenceSep 12, 2025
  If the oil temperature light is illuminated and the engine RPM is low on your Exmark Lawn Mower, the Engine Control Unit may have limited engine RPMs, known as 'limp' mode. Check the oil level. If the level is above 'add', contact an Authorized Service Dealer.
C
Cindy StanleySep 14, 2025
What does it mean if the oil pressure light is on and engine RPM is low on my Exmark LAZER Z X?
- C
  clarksarahSep 14, 2025
  If the oil pressure light is on and the engine RPM is low on your Exmark Lawn Mower, the Engine Control Unit has likely limited engine RPMs, which is known as 'limp' mode. Let the engine cool down and check the oil level. If the level is above the 'add' mark, contact an Authorized Service Dealer.

Exmark LAZER Z X Series Specifications

General

Engine Type	V-Twin
Transmission	Hydrostatic
Engine Brand	Kawasaki
Cutting Width	60 inches
Deck Construction	Fabricated steel
Seat Type	High-back with armrests
Category	Commercial
Engine	Kawasaki
Deck Type	Fabricated
Weight	1, 495 lbs
Warranty	5-year limited