Extech Instruments SDL700 User Manual (English)

To Next Page

To Previous Page

4 SDL700-EU-EN V1.4 03/12

Setup Mode

Basic settings at a glance

To view the current configuration of the meter with regard to time, date, and datalogging sampling

rate press the SET button momentarily. The meter will now display the configuration in quick

succession. If the information is missed on the first try, simply press the SET button again until all of

the information is noted.

Accessing the Setup mode

1. Press and hold the SET button for at least 1.5 seconds to access the Setup menu.

2. Press the SET button momentarily to step through the available parameters. The parameter

type is shown on the bottom of the LCD and the current selection for that type is shown above

it.

3. When a parameter is displayed that is to be changed, use the arrow keys to change the

setting. Press the ENTER button to confirm a change.

4. Press and hold the SET button for at least 1.5 seconds to exit the Setup mode. Note that the

meter automatically switches out of the Setup mode if no key is pressed within 7 seconds.

The available Setup parameters are listed below. Additional detailed information is provided

below this list:

dAtE

Set the clock (Year/Month/Date; Hours/Minutes/Seconds)

SP-t

Set the datalogger sampling rate (Hours/Minutes/Seconds)

PoFF

Automatic power-off management (Enable or disable the auto-power off function)

bEEP

Set the beeper sound ON/OFF

dEC

Set the numerical format; USA (decimal: 20.00) or European (comma: 20,00)

Sd F

Format the SD memory card

tYPE

Select the pressure range type (

2, 5, 10, 20, 50, 100, 200, and 400 Bar

)

Setting the Clock Time

1. Access the dAtE parameter.

2. Use the arrow keys to change a value

3. Use the ENTER button to step through the selections

4. Press and hold the SET button for at least 1.5 seconds to exit to the normal operation mode (or

simply wait 7 seconds for the meter to automatically switch to the normal operating mode).

5. The clock will keep accurate time even when the meter is switched off. However, if the battery

expires the clock will have to be reset after fresh batteries are installed.

Setting the Datalogger Sampling Time (Rate)

1. Access the SP-t parameter.

2. The sampling rate can be set from ‘0’ seconds (manual log mode) up to 8 hours, 59 minutes,

and 59 seconds.

3. Use the ENTER button to move through the Hours, Minutes, and Seconds digit groups and use

the arrow keys to change the digit values.

Press the ENTER button to confirm the entry.

5. Press and hold the SET button for at least 1.5 seconds to exit to the normal operation mode (or

simply wait 7 seconds for the meter to automatically switch to the normal operating mode).

netzerotools.com

Need help?

Do you have a question about the Extech Instruments SDL700 and is the answer not in the manual?

Extech Instruments SDL700 Specifications

General

Display	LCD
Data Logging	Yes
Sound Level Range	30 to 130dB
Light Range	0 to 20, 000 Lux
Resolution (Sound)	0.1dB
Resolution (Light)	1 Lux
Resolution (Humidity)	0.1%RH
Resolution (CO2)	1ppm
Measurement Range (Light)	0 to 20, 000 Lux
Resolution (Light Meter)	1 Lux
Resolution (Temperature)	0.1°F / 0.1°C
Sampling Rate	1 second
Humidity Range	10 to 90%RH
Accuracy (Light)	±5%
Accuracy (Humidity)	±3% RH
Accuracy (Light Meter)	±5%