8 SDL700-EU-EN V1.4 03/12
Spreadsheet data example
RS-232/USB PC Interface
The optional 407001A software kit (software and cable) allows streaming of data to a PC via
the RS232 Output jack.
AC Power Adaptor
This meter is normally powered by six (6) 1.5V ‘AA’ batteries. An optional 9V power adaptor is
available. When the adaptor is used, the meter is permanently powered and the power button will
be disabled.
Battery Replacement and Disposal
When the low battery icon appears on the LCD, the batteries must be replaced. Several hours
of accurate readings are still possible in this condition; however batteries should be replaced as
soon as possible:
• Remove the two (2) Phillips screws from the rear of the meter (directly above the top of the tilt
stand).
• Remove and safely place the battery compartment and screws where they will not be damaged
or lost.
• Replace the six (6) 1.5V ‘AA’ batteries observing polarity.
• Replace the battery compartment cover with the two (2) Phillips screws.
All EU users are legally bound by the battery ordinance to retu
rn all used batteries to
collection points in your community or wherever batteries / accumulators are sold!
Disposal in the household garbage is prohibited!
To Next Page
Loading...
Need help?
General
