Extollo LANPlug 2000 - Determining the IP Address

The information contained within this document is confidential and cannot be reproduced
without the approval of Extollo Communications.
22
Logging into the LANPlug 2000
Determining the IP Address
Step 1
The LANPlug 2000 has an integrated web Graphical User Interface (GUI) for management
purposes. It also has Dynamic Host Configuration Protocol (DHCP) enabled, which means that
the LANPlug 2000 will automatically
obtain an IP address from the Internet router.
To access the web GUI on the LANPlug 2000, the IP address that was assigned to the LANPlug
2000 is required. To determined what IP address was assigned to a LANPlug 2000, log into the
Internet router and see what devices are connected and their associated IP address.
For example: Below is a captured window from an Internet router that shows the connected
devices and their assigned IP addresses. The “unknown” devices are the LANPlug 2000’s which
were assigned the IP address of 192.168.1.65 and 192.168.1.67.
NOTE: The IP addresses assigned to your LANPlug 2000 may differ from this example.