The information contained within this document is confidential and cannot be reproduced
without the approval of Extollo Communications.
32
Restoring the LANPlug 2000 to Factory Default
This section describes the process to restore the LANPlug 2000 to its factory default settings.
Performing this process erases all settings that have been configured on the LANPlug 2000.
1. Hold the Pairing button down for more than 20 seconds until the Powerline and Ethernet
LEDs turn on.
2. Release the pairing button.
3. The LANPlug 2000 reboots and restores all settings to factory defaults.
4. The Powerline LED turns amber once the process is completed.
5. Perform the pairing procedure to add the LANPlug 2000 to the Powerline network.
To Next Page
Loading...