The information contained within this document is confidential and cannot be reproduced
or shared without the approval of Extollo Communications.
24
3. The blinking Powerline LED indicates that the pairing process has started. The pairing
process takes approximately 40 to 60 seconds to complete.
4. The pairing process is complete when the Powerline LED on the Una connected to the
Internet router stops blinking and is solid green and the new Una’s Powerline LED is solid
green.
5. Once paired, the new Una is automatically incorporated into the network. The Una
designated as CAP automatically performs a topology discovery to locate and authenticate
the new Una that was added to the network. It then performs an auto synchronization of
the Wi-Fi parameters (SSID & Password).
Pairing Tip
The easiest way to pair Una’s without having to run all-over the house is to plug them into a power
bar that has multiple electrical outlets.
1. Plug the Una’s into the power bar.
2. Connect one of the Una’s to the Internet router with the provided Ethernet cable.
3. Follow the pairing procedure.
4. Once the pairing process is complete, remove Una’s from the power bar. Plug the Una
that is connected to the Internet router into an electrical outlet close to the router. Plug the
remaining Una’s directly into the electrical outlets in arears that require a stronger Wi-Fi
connection.
NOTE: The pairing & Wi-Fi configuration parameters are stored in flash memory. Therefore, it is
not lost when the unit is unplugged.
To Next Page
Loading...