The information contained within this document is confidential and cannot be reproduced
or shared without the approval of Extollo Communications.
41
Troubleshooting Una
None of the LED’s Light Up After Installation
• Unplug/Re-plug Una from the electrical outlet. Una takes approximately 90 seconds to
completely boot-up.
• Una is completely booted-up when the Powerline and Wi-Fi LED’s are amber.
• Make sure there is power to the electrical outlet and it’s working properly.
• Ensure Una is not plugged into an extension cord, power strip, or surge protector.
Power LED is Off:
• Make sure there is power supplied to the electrical outlet.
• Ensure Una is securely plugged directly to the electrical outlet.
• Try another electrical outlet.
• Reset the Una to factory defaults and perform the pairing process.
Wi-Fi LED is off:
• Try a different electrical outlet.
• Reset Una to factory defaults and perform the pairing process.
• Reconfigure Una’s Wi-Fi.
The Ethernet LED Does Not Light Up:
• The Ethernet LED indicator on the Powerline adapter will light up once it detects a network
device plugged into the Ethernet port.
• Check if the Ethernet cable is securely connected.
• Make sure that the device you are connecting to the LANPlug 2000 is powered ON.
• Check the Ethernet adapter on your computer to see if it is working/enabled.
• Try a different Ethernet cable.
Una Suddenly Stops Working
• Perform a power cycle of the adapter.
• Perform a reset to factory default and perform the pairing procedure.
Contact Technical Support
support@extollocom.com
To Next Page
Loading...