Extraflame Pellet stove - STAND-BY FUNCTION AND KEY LOCK; Stand-By Function Configuration

ENGLISH
STBY FUNCTION SET AT OFF DEFAULT SETTING
If the Stby function is not active (OFF), if the stove reaches the set room temperature, it will go to minimum, modulating and
displaying modulate. When the room temperature is below the setting, it will start to work again at the set power and displaying
work.
STAND  BY WITH ADDITIONAL THERMOSTAT
The STBY function is used if immediate stove switch-o is required when the set temperature has been reached.
By default the STBY function is always set on OFF (light
on).
STBY FUNCTION SET AT OFF DEFAULT SETTING
If the STBY function is not active (OFF), if the stove reaches the set room temperature, it will go to minimum, modulating
and displaying MODULATE. When the room temperature is below the setting, it will start to work again at the set power and
displaying WORK.
STBY FUNCTION SET AT ON
When the STBY function is activated (ON), the stove, upon reaching the set room temperature and exceeding it by 2°C,
will switch o after a pre-set default delay, displaying STAND - BY.
When the room temperature is 2°C lower than the setting, the stove will start to work again at the set power
displaying WORK.
CONTROLS PROCEDURE
 Press key 5 for a few seconds, until SET CLOCK appears.
 Press key 3 several times until USER is displayed.
 Conrm using key 5.
 Press key 5 several times to reach STANDBY.
 Using key 2 or 3 select at ON.
 Press key 5 to conrm and key 1 to return to the previous menus
up to the initial status. The STANDBY function is active.
KEYS LOCKED
The menu allows to lock the display keys (like with mobile phones).
With the function engaged, every time a key is pressed, “KEYS LOCKED” will appear.
CONTROLS PROCEDURE
 Press key 5 for a few seconds, until SET CLOCK appears.
 Press key 3 several times until USER is displayed.
 Conrm using key 5.
 Press key 5 until "KEYS LOCKED" appears.
 Use keys 2 -3 to select enable/disable.
 Press key 5 to conrm and key 1 to return to the previous menus
up to the initial status.
J
ONCE THE FUNCTION IS ACTIVATED, USE KEYS 1 AND 5 AT THE SAME TIME TO LOCK OR UNLOCK THE
KEYBOARD
31