Extraflame Pellet stove - V2 - Air; Reset; Enable Chrono; Chrono

ENGLISH
CHRONO
The chrono allows to program 4 time spans within a day to use every day of the week.
The switch-on and switch-o time can be set in every time slot, along with the days of use of the programmed time slot
and the desired room temperature (07 - 40°C).
RECOMMENDATIONS
The ignition and switch-o times must be within the arc of
one day, from 0 to 24 and not over several days:
Before using the chrono function, set the current day and
time. Therefore check that the points listed in the “Set clock”
sub-chapter have been followed, so that the chrono function
works. Aside from programming it, activate it as well.
EXAMPLE:
SWITCHON TIME 07:00
SWITCHOFF TIME 18:00
CORRECT
IGNITION 22:00
SWITCHOFF 05:00
INCORRECT
V2  AIR
The menu allows to adjust the speed of the ducted fan in percentage.
CONTROLS PROCEDURE
 Press key 5 for a few seconds, until SET CLOCK appears.
 Press key 3 several times until USER is displayed.
 Conrm using key 5. Press key 5 until "V2 AIR" appears.
 Use keys 2 -3 to increase (3) or decrease (2)
 Press key 5 to conrm and key 1 to return to the previous menus
up to the initial status.
2
ENABLE CHRONO
It allows to enable/disable the chrono and the various time slots.
CONTROLS PROCEDURE
 Press key 5 for a few seconds, until SET CLOCK appears.
 Press key 5 several times until ENABLE CHRONO is displayed.
 Press key 5 to conrm and use keys 2-3 to enable "ON" or disable "OFF" the chrono.
 Use keys 4 -5 to select the desired time slot
 Use keys 2-3 to enable "ON" or disable "OFF" the selected time slot.
 Press key 1 several times to conrm and exit the menu.
RESET
Allows to reset all values modiable by the user to the default values.
CONTROLS PROCEDURE
 Press key 5 for a few seconds, until SET CLOCK appears.
 Press key 3 several times until USER is displayed.
 Conrm using key 5. Press key 5 until "RESET" appears.
 Press keys 2-3 to select ON and press key 5.
 "DONE" will appear on the display to conrm
32