Summit 200 Series Switch Installation and User Guide 207
16 Interior Gateway Routing Protocols
This chapter describes the following topics:
• Overview on page 207
• Overview of RIP on page 208
• Overview of OSPF on page 210
• Route Re-Distribution on page 215
• Configuring RIP on page 217
• RIP Configuration Example on page 219
• Displaying RIP Settings on page 220
• Resetting and Disabling RIP on page 220
• Configuring OSPF on page 220
• Displaying OSPF Settings on page 226
• Resetting and Disabling OSPF Settings on page 227
This chapter assumes that you are already familiar with IP unicast routing. If not, refer to the following
publications for additional information:
• RFC 1058—Routing Information Protocol (RIP)
• RFC 1723—RIP Version 2
• RFC 2328—OSPF Version 2
• Interconnections: Bridges and Routers
by Radia Perlman
ISBN 0-201-56332-0
Published by Addison-Wesley Publishing Company
Overview
The switch supports the use of two interior gateway protocols (IGPs); the Routing Information Protocol
(RIP) and the Open Shortest Path First (OSPF) protocol for IP unicast routing.
RIP is a distance-vector protocol, based on the Bellman-Ford (or distance-vector) algorithm. The
distance-vector algorithm has been in use for many years, and is widely deployed and understood.
To Next Page
Loading...
Need help?
General
