EasyManuals Logo

Extreme Networks 200 Series User Manual

Extreme Networks 200 Series
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #217 background imageLoading...
Page #217 background image
Route Re-Distribution
Summit 200 Series Switch Installation and User Guide 215
Route Re-Distribution
Both RIP and OSPF can be enabled simultaneously on the switch. Route re-distribution allows the
switch to exchange routes, including static routes, between the two routing protocols. Figure 37 is an
example of route re-distribution between an OSPF autonomous system and a RIP autonomous system.
Figure 37: Route re-distribution
Configuring Route Re-Distribution
Exporting routes from OSPF to RIP, and from RIP to OSPF, are discreet configuration functions. To run
OSPF and RIP simultaneously, you must first configure both protocols and then verify the independent
operation of each. Then you can configure the routes to export from OSPF to RIP and the routes to
export from RIP to OSPF.
EW_01
9
OSPF AS
Backbone Area
0.0.0.0
Area
121.2.3.4
ABR
ASBR ASBR
RIP AS

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Extreme Networks 200 Series and is the answer not in the manual?

Extreme Networks 200 Series Specifications

General IconGeneral
BrandExtreme Networks
Model200 Series
CategorySwitch
LanguageEnglish

Related product manuals