Extreme Networks 200 Series - Configuring IGMP and IGMP Snooping

232 Summit 200 Series Switch Installation and User Guide
IP Multicast Routing and IGMP Snooping
PIM-SM Commands
Table 69 summaries the PIM-SM commands available on the Summit 200:
Table 69: PIM-SM Commands
Command Description
configure pim {add | delete} {vlan} <vlan
name> sparse {passive}
Configures or unconfigures PIM-SM on an IP
interface. Specify the following:
• add—Configures PIM-SM on an IP interface.
• delete—Configures PIM-SM on an IP
interface.
• vlan—Configures or unconfigures PIM-SM on
all VLANs.
• vlan name—Configures or unconfigures
PIM-SM on a specific VLAN.
• passive—Enables or disables an interface
as passive. To specify an active interface,
omit this option.
configure pim crp static <rp address> [none |
<access profile>] {<priority [0-254]>}
Configures an RP and its associated groups
statically. The switch may not be configured
dynamically. Specify the following:
• rp address—The IP address of the
rendezvous point (RP).
• access profile—The list of multicast
group accesses served by the RP.
• priority—A priority setting. The range is 0 -
254.
configure pim register-checksum-to
[include-data | exclude-data]
Configures the checksum computation to either
include data or to exclude data in the register
message. Specify either:
• include-data—Use to be compatible with
Cisco Systems products.
• exclude-data—Use for RFC-compliant
operation.
configure pim spt-threshold <last hop router
threshold> <rp threshold>
Configures the threshold for switching to SPT.
• last hop router threshold—The last
hop router threshold in Kbps.
• rp threshold—The rendezvous point (RP)
threshold in Kbps.