Extreme Networks 200 Series - Port Errors

Reviewing ExtremeWare Vista Statistical Reports
Summit 200 Series Switch Installation and User Guide 285
Figure 77: Port Collisions
Port Errors
In this window, you can review Ethernet link errors. As shown in Figure 78, the table reflects the
following information for each active port:
• Link State
• Rx Lost
• Rx Bad Cyclic Redundancy Check (CRC)
• Rx Undersize
• Rx Oversize
• Rx Fragments
• Rx Jabber
• Rx Alignment
• Tx Errored
• Tx Deferred
• Tx Late Collisions
For stacked switches, you can filter by the report to only show the port errors on the stack master (slot
1).