Extreme Networks AP-7562 - Installation Guidelines, Safety, and Placement

Introduction
AP-7562 Installation Guide
9
Pin 4 - Ground
Package Contents
Carefully remove all protective packing material around the AP-7562 Access Point and save
the container for storage. Refer to <bl_blue><em_Emphasis>Hardware and Mounting
Accessories on page 7 when verifying all AP-7562 hardware has been received.
When opening the shipping cartons, inspect the equipment for damage. If you find any
damaged equipment or any equipment is missing, contact Support immediately.
Each AP-7562 Access Point (see <bl_blue><em_Emphasis>Hardware and Mounting
Accessories on page 7) includes the following parts:
• AP-7562 Access Point
• Weatherproof RJ45 plug kit (except M12 connector models)
AP-7562 Access Point Installation Guide (this document)
Hardware Installation Guidelines
NOTE
Record the serial numbers on the shipping cartons and AP-7562 Access Points
for warranty claims and reference during software download procedures.
CAUTION
All device wiring must comply with the National Electric Code (NEC) or
regulations and procedures defined by the regulatory bodies of the country or
region where the devices are being deployed. All local building and structure
codes must be observed.
WARNING
Strictly observe safety precautions and warnings when installing an AP-7562
Access Point.