Extreme Networks AP-7562 - VMM Power Options

Introduction
AP-7562 Installation Guide
19
VMM Power Options
A mounted AP-7562 operating as a VMM within a vehicle or mobile asset requires a power
source delivered via Power over Ethernet (PoE). A professional certified installation partner
should be consulted in respect to appropriate power sources and installation within a
vehicle or mobile asset. A vehicular power source is not provided. No responsibility is taken
for any power source design operated outside of the allowed specifications for power of an
AP-7562 operating as a VMM.
The following table shows a number of potential power sources and corresponding industry
options to power an AP-7562 VMM:
WARNING
Exceeding these listed power requirements can invalidate the Access Point
warranty.
Potential Vehicular/Mobile
Power Sources
Required Source
12V battery DC-DC convertor or DC PoE injector
24V battery DC-DC convertor or DC PoE injector
12V power plug DC PoE injector with power plug
adapter
AC inverter within vehicle AC PoE injector
PoE switch in train or vehicle Direct connection via CAT5E cable