Introduction
AP-7562 Installation Guide
18
5 Insert four screws with washers through the holes of the three plates and into the screw
holes on the bottom of the VMM.
6 Using a 5mm allen wrench or box wrench, tighten the screws to 150 inch pounds (lbf-in).
7 Set the VMM and top bracket sub-assembly aside.
8 Locate the mount point position for the VMM in the vehicle. Ensure there is sufficient
clear
ance for cables and antennas. The surface should be metal (1.0 mm minimum
thickness), hard plastic or plywood, and capable of supporting the weight of the VMM
and bracket assembly.
9 Attach the vehicle mount securely to the mount point with metal screws or bolts (not
pr
ovided).
10 Securely attach the AP-7562 top bracket sub-assembly to the vehicle mount with the
f
our pre-installed thumb screws. Tighten the screws to 90 inch pounds (lbf-in) using a
philips screwdriver or pliers.
11 Attach three RP-SMAF adapters (part number
25-90263-02R) to the N connectors on
the active mobile radio on the VMM. Radio 1 ports are labeled R1-A, R1-B, and R1-C.
Radio 2 ports are labeled R2-A, R2-B, and R2-C.
12 Attach the antennas to the adapters
for each radio to be enabled.
13 Connect the CAT5E cable providing power t
o the RJ45 port labeled GE1/POE.
14 Select an Access Point Mode from the available options.
WARNING
Connecting power to any other port could damage the unit.
To Next Page
Loading...
