Hardware Mounting and Installation
AP-7562 Installation Guide 35
Power Options Using Power over Ethernet
Power over Ethernet (PoE) is the power source for an AP-7562 Access Point. For optimal
performance, an AP-7562 can be powered by the following injectors and RFS controllers
that support 802.AT PoE.
For installations requiring an outdoor PoE injector, the following options are recommended:
• AP-PSBIAS-7161-US
• AP-PSBIAS-7161-WW
The AP-PSBIAS-7161 is a 1-Port 802.3at PoE Gigabit Ethernet injector. The injector is IP66
rated for outdoor deployments when used with the weatherproof kit supplied.
There are two power cord options. The AP-PSBIAS-7161-US comes equipped with a cable
with a standard three prong power plug. This plug can be removed by the installer if
required when connecting to an AC source. The AP-PSBIAS-7161-WW comes equipped with
a cable with open leads. Mounting kits are not supplied (see
<bl_blue><em_Emphasis>Hardware and Mounting Accessories on page 7 for mounting kit
part numbers).
If located within 100 meters of the controller and a PoE port is available, the AP-7562
Access Point can also be connected directly to a WLAN or Integrated Services Controller
running WiNG 5.6 or higher.
A standard CAT5E cable can be used to provide the connection to the AP-7562. The GE1/
POE port on the AP-7562 is where the standard CAT5E cable will connect to the Access
Point and use of the weatherproof RJ45 plug kit that comes with the unit will maintain a
weatherproof seal for outdoor installation at the ethernet port.
If a CAT5E cable is used to connect the Access Point to an RFS controller through a
building egress, a suitable lightning protection system should be considered. A professional
installer should be consulted to identify an appropriate system.
NOTE
Product installation and mounting instructions are provided with the outdoor
power injector.
To Next Page
Loading...
