Introduction
AP-7562 Installation Guide
7
Hardware and Mounting Accessories
The AP-7562 is a Power over Ethernet (PoE) device. When deployed, the use of an outdoor
rated PoE power supply and mounting bracket may be required. The recommended PoE
accessories are listed in the following table:
Mounting Accessories
The AP-7562 has a flexible three piece mounting kit (
KT-147407-01)
, together with an
optional standoff extension arm (
KT-150173-01)
for pole mounting
. Additionally, the KT-
147407-02 stainless steel hardware mounting bracket kit
is available for deployments in
corrosive environments.
Weatherized Ethernet Accessories
One RJ45 weatherized connector plug is included with each AP-7562 Access Point (except
M12 connector models). If additional plugs are required, they can be ordered using the
following part number:
Refer to the installation instructions included with the RJ45 weatherized connector plug for
proper procedure to form a drip loop with the cable.
M12 Console Port Connections
Part Number Description
AP-PSBIAS-7161-US Outdoor IP66 802.3AT gigabit Ethernet power injector,
100-240 VAC US
AP-PSBIAS-7161-WW Outdoor IP66 802.3AT gigabit Ethernet power injector,
100-240 VAC International
KT-153143-01 Outdoor PoE mounting kit
Part Number Description
KT-147407-01 Hardware mounting kit
KT-150173-01 12 inch extension arm for mounting kit
KT-147407-02 Stainless steel hardware mounting kit
Part Number Description
KT-153676-01 RJ45 weatherized connector plug
CAUTION
When connecting RJ45 cables, ensure cables are connected to the Access Point
from the bottom, and include a drip loop to prevent moisture intrusion. Cover
the Ethernet cable with self-healing weatherproofing tape.
To Next Page
Loading...
