Extreme Networks AP-7562 - Basic Access Point Configuration

37AP-7562 Installation Guide
3
Basic Access Point
Configuration
Once the Access Point is installed and powered on, complete the following WiNG Assist
configuration steps to get the Access Point up and running with minimal administrative
intervention.
Startup Assist updates existing settings. To delete or revise existing Startup Assist settings,
either rerun Startup Assist or navigate to where those parameters appear in the user
interface and update them accordingly. Refer to the Access Point’s more advanced
configuration documentation available on the Extreme Networks support site for updating
the management interface beyond the scope of the WiNG Assist configuration described in
this guide. For more information, see http://documentation.extremenetworks.com
1 Power the Access Point using an appropriate po
wer adapter, PoE injector, or PoE switch.
2 Connect to the Access Point.
• If deploying an Express Access Point, connect to the "ExpressXXYY" SSID
• If deploying an Enterprise Access Point, the default IP address is located on the
backside of
the Access Point.
3 Enter the default username admin in the Username field.
4 Enter the default password adm
in123 in the Password field.