Basic Access Point Configuration
AP-7562 Installation Guide 38
5 Select the Login button to load the management interface.
6 If logging in using a factory default configurat
ion, Startup Assist automatically displays.
If Startup Assist does not automatically display, it can be invoked at any time from the
up
per-left of the Basic Configuration screen.
7 Set the following Startup Assist parameters:
• V
irtual Controller - Select this option to set this Access Point as a Virtual Controller
capable of managing and provisioning up to 24 Access Points of the same model.
Those Access Points managed by this Virtual Controller list this Access Point's AP
Name as its own. Only one Virtual Controller can be designated.
• Co
untry Name - Set the country specific to this Access Point's deployment location.
Selecting the correct country is central to legal operation. Each country has its own
NOTE
Startup Assist automatically sets the radio transmit power and enables Auto Channel
selection. The Access Point's name is automatically assigned based on the Access Point
type and the last three octets of the device's hardcoded MAC address. WLAN 1 and
WLAN 2 both use VLAN ID 2200 by default. To adjust any of these parameters, edit the
appropriate configuration screen directly. Refer to the Access Point reference material
available on Extreme Networks Support for configuring the Access Point beyond the
scope of the minimal WiNG Assist configuration described in this guide. For more
information, go to http://documentation.extremenetworks.com
To Next Page
Loading...
