Hardware Mounting and Installation
AP-7562 Installation Guide 23
The following ancillary hardware to attach the extension arm to the mounting bracket is
included in the extension arm kit:
Pole Mounted Installations
The mounting hardware kit and extension arm can be used in various combinations to
properly install the AP-7562 on a pole. For poles up to 3 inches in diameter, attach the pole
mount bracket of the mounting hardware kit at the desired position on the pole using band
clamps up to 3/4 inch width, or a 1/2 inch x 4 inch wide U-bolt and nuts. For poles greater
than 3 inches in diameter, attach the pole mount bracket using band clamps.
Description Quantity
1/2 inch hex head nut 2
1/2 inch x 3/4 inch hex head bolt 2
CAUTION
Always mount the AP-7562 with the black gore vent facing down.
NOTE
The U-bolt and band clamps are not included in the mounting bracket kit.
To Next Page
Loading...
