EasyManua.ls Logo

Extreme Networks AP-7562 - Power Supply; Radio Frequency Interference Requirements - FCC; Radio Transmitters (Part 15); Radio Frequency Interference Requirements - Canada

Extreme Networks AP-7562
61 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Regulatory Information
Installation Guide 46
Power Supply
This device must be powered from a 802.3af or 802.3at compliant power source which has
been certified by the appropriate agencies, or by a LISTED Type no. PWRS-14000-247R or
AP-PSBIAS-2P3-ATR, direct plug-in power supply, marked Class 2 or LPS (IEC60950-
1,SELV). Use of alternative Power Supply will invalidate any approvals given to this unit and
may be dangerous
Radio Frequency Interference Requirements - FCC
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Radio Transmitters (Part 15)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Radio Frequency Interference Requirements - Canada
For RLAN Devices:
The use of 5 GHz RLAN's, for use in Canada, have the following restrictions:
Restricted Band 5.60 - 5.65 GHz
Tested to Comply
With FCC Standards
For Home or Office Use
Symbol Technologies Inc.

Table of Contents

Related product manuals