Hardware Mounting and Installation
AP-7562 Installation Guide 24
Vertical Pole Mount
Use the following procedure for vertical pole mount installations. The extension arm is
recommended when mounting the Access Point to poles greater than 3 inches is diameter.
For poles up to 3 inches in diameter when using a U-bolt:
1 Thread two 1/2 inch nuts onto the U-bolt.
2 Position the U-bolt on the pole and place the
pole mount bracket on the U bolt. Adjust
the two 1/2 inch inner nuts until the pole mount bracket is against the pole and the U-
bolt can be secured tightly to the pole at the desired mounting location.
3 Place the angle adapter bracket on the U-bolt with the open slot connections on the
bottom and align it with the pole mount. Attach with two 1/2 inch nuts. Tighten all nuts
to 300 inch pounds (lbf-in).
NOTE
The use of an extension arm is recommended for installations on poles greater
than 3 inches in diameter.
To Next Page
Loading...
