Hardware Mounting and Installation
AP-7562 Installation Guide 34
adapter bracket. Insert two M6 hex flange screws into the top holes on the angle
adapter bracket.
4 Use a torque wrench or a ratchet and a 10mm sock
et, or an adjustable wrench, to finish
attaching the angle adapter bracket to the Access Point bracket with the four M6 hex
flange screws in the open slot connections and the top holes on the angle adapter
bracket. Do not tighten the screws until all rotation and tilt adjustments are complete.
5 To adjust the position of the Access Point, rotate the Access Point bracket (plus or minus
15 de
grees) and tilt the angle adapter bracket (up to 45 degrees).
6 Use a torque wrench or a ratchet and a 10mm
socket, or an adjustable wrench, to
tighten all screws when all adjustments are complete.
7 Tighten all hex flange screws to 60 inch pounds (lbf-in).
To use the extension arm with the mounting hardware kit:
1 With the open slot connections facing down, attach the angle adjust bracket at the
de
sired mounting location using four #10/32 lag bolts.
2 Complete the steps for assembling and positioning the angle adapter bracket and
A
ccess Point bracket sections outlined above. See <bl_blue><em_Emphasis>Vertical
Pole Mount on page 24.
3 With the Access Point positioned so the gore vent is facing down, attach the extension
arm t
o the Access Point bracket with two ½ inch bolts and nuts. Tighten bolts to 300
inch pounds (lbf-in).
To Next Page
Loading...
